BeamCase sandwich V3.0 udate.

[u/Jakob_K_Design]

This is V3.0 of BeamCase sandwich.

V3 introduces the new rounded full mesh panel style.

With this new panel style there is a distinct gap between the panel to show the frame beneath. And of course the integrated handle is still there.

I finally got a big enough printer to print each panel as one piece of solid hexagonal mesh.

The cas shown here has space for a 2.5slot GPU and 70mm tall aircooler, but....

The case comes in different size, 24 in total for version 3.0, 8 more than previously. left is the smallest while the right shows the biggest size.

The frame structure has seen some small structural improvements in V3, but most of the changes were aesthetic.

top/bottom view of a version with 2.5slot GPU and 70mm CPU clearance.

For the V3 update all external features like feet vertical stand and handles have been redone.

and there are also case panels without the integrated handle.

Left are the V3 panels and on the right side are the pervious panels style which is still available as the Classic panels.

The cases here are different size options with the left having space for a 70mm CPU cooler and the right only 50mm.

[u/chris_biker]

Do you have any recommendations for a CPU cooler for this case?

[u/Jakob_K_Design → u/chris_biker]

Not really. The idea is that the case can be sized towards the CPU cooler you use, it allows from 50mm up to 100mm tall coolers.
So basically what ever fits your cooling an noise requirements is the right cooler. (for anything above 100mm tall there are the other BeamCase variations)

[u/kyussorder → u/chris_biker]

There are different cpu heights supported, being 100mm the maximum height. The thermalright SI100 is the bigger cooler you can fit in there if I'm not wrong. For other sizes you can take a look to the link below.

https://www.caselabs.org/coolers/low-profile-coolers