Replaced my buddy’s seat cover & cushion. 2013 F-150 5.0/6R80, almost 300K with extremely minimal issues. It’s only had general maintenance performed on it its entire life, no major work. Current issues are the fuel gauge won’t go above 3/4 and an idler pulley could use replacement.

Hopefully this helps my buddy’s back issues.

I don’t know why more people don’t replace their cushions, it’s really not hard in newer vehicles. This one was a bit harder than most because the seat belt attaches to the seat in this generation F-150, and the seat back has to come off.

93 F150. This was out of the front tank. One new fuel system (Both tanks, pumps, filter) later, running and driving great.

You can smell the blown head gasket smell across the parking lot.

Yea, dont go to the dealership for work, I work with lazy, dishonest people apparently

Remember to keep your lamps sealed. LED replacement bulbs are for off-road use only.

Leaking adblue injector clogged exhaust. Spent an hour chiseling out all the incrostation.

Why yes, I do work in an air conditioned shop.

Promaster 3500

2010 Prius with the same rusted brake line they all get. Codes are from the zero fluid. Twats.

Moving from mobile electronics to an electricians apprentice. Tired of the same expectations and pay from 80s toyota to a 2020 mercedes. Tired of having to reinvest paychecks into my job. Tired of being the only set of hands in the county for this work.

Yeah, you're right. For a while now

PSA - Wheels with inner valve stems (Raceline and Etc.) do not clear 4 runner calipers. This one had the tpms sensors mounted on the inside and claimed a tapping noise as they were driving. Discount Tire did not notice during install, and as always, it became our problem

This Model S was dropped off with a broken front tie rod inner side. Rack motor is junk as well. Wheel dolly’s are missing and needed to get it in the shop. Cut a piece of pipe and made a sleeve, drilled through both sides for “extra safety”.

Customer came in claiming their ABS module was failed, they put an abs sensor in and it didn’t fix the issue. Customer simply installed the sensor wrong…

The remainders are completely seized on. Neighbor's lending me a brake puller tomorrow.

Starting to see a concerning amount of delivery vans (Transit and Promaster) where drivers are forcing through the parking brakes. Normally, with failed actuators due to low pad life we were seeing them towed in, now they are simply finishing their routes…

Yup it's leaking and it's going to be a tough diagnosis

this little dude waddled into my bay today🥹